GP-Extreme 12W Thermal Pad, 80 x 40 x 0.5 mm
12 W/mK · 80 × 40 × 0.5 mm
4.7 3,062 ratingscounted across all 5 thicknesses of this sheet size
Thermal Pads
GP-Extreme 12W Thermal Pad, 120 x 120 x 1.0 mm
4.4 124 ratingscounted across all 5 thicknesses of this sheet size
A 120 x 120 mm sheet of 1.0 mm GP-Extreme, 12 W/mK, sized for shops that fit the most common gap several times a week.
$21.95
Low stock at our retail partner
Sold and shipped by an authorized retail partner. Price shown was current when this page was built.
Check price and buy- Model
- TP-GP01-S-B
- Conductivity
- 12 W/mK
- Sheet size
- 120 × 120 mm
- Thickness
- 1 mm
- In the pack
- 1 sheet
- Series
- GP-Extreme
- Category
- Thermal Pads
One millimeter is the thickness most benches consume fastest, and the large square is the answer to consuming it fast. This 120 x 120 mm sheet of 12 W/mK GP-Extreme holds enough material for a run of motherboards, a shelf of graphics cards or a season of laptop refreshes, without the packaging and the reordering that the same area in small sheets would involve.
Stock the size you actually use
Look at what leaves the drawer over a few months and one or two thicknesses will dominate. For most workshops 1 mm is one of them. Holding the everyday size in bulk and the outliers in single sheets matches the money to the workload, rather than spreading it evenly across sizes that rarely get touched.
Nesting cuts to reduce waste
Draw the pieces on the liner before the blade comes out. Long strips along one edge, small islands nested into the gaps between them, and the remainder left as a clean rectangle rather than a lace of holes. Ten minutes of planning on a large sheet routinely saves more material than the planning costs in time.
A note on what thickness cannot fix
A bulk sheet makes it easy to be generous, and generosity is the wrong instinct with interface material. More thickness than the gap needs holds the assembly apart and lengthens the thermal path. Cut to the measurement even when there is plenty of material, because the pad that helps is the one that fits.
Cutting tools for a large square
A rotary cutter and a long steel rule work better on a 120 mm run than a craft knife, because a single continuous pass leaves a truer edge than several overlapping ones. Whatever the tool, replace the blade before starting: dragged edges are the most common defect in shop-cut pads.
Also in Thermal Pads
GP-Ultimate 15W Thermal Pad, 90 x 50 x 0.5 mm
15 W/mK · 90 × 50 × 0.5 mm
4.7 1,021 ratingscounted across all 5 thicknesses of this sheet size
GP-Ultimate 15W Thermal Pad, 90 x 50 x 0.5 mm (2 pcs)
15 W/mK · 90 × 50 × 0.5 mm · 2 sheets
4.8 734 ratingscounted across all 4 thicknesses of this sheet size
GP-Ultimate 15W Thermal Pad, 120 x 20 x 0.5 mm (2 pcs)
15 W/mK · 120 × 20 × 0.5 mm · 2 sheets
4.6 491 ratingscounted across all 4 thicknesses of this sheet size